I misplaced the crankshaft from my C8DE-6015-B block, so I need a replacement. This block has 7 mains and dual-pattern bell-housing.
This block can obviously take either the little BH for the 2.77 trans or the larger BH for the 3.03 trans.
So it can take either the "dished" flywheel that goes with the 2.77 trans or the "flat" flywheel that goes with the 3.03 trans.
The question is -- is the same ~crankshaft~ used for both flywheels?
OR -- do both flywheels have the identical bolt-circle pattern?
OR - will the crankshaft from an earlier-year block -- say from a C5DE 200 CID block with ONLY the small BH pattern -- work in the C8DE block with the "flat" flywheel?
This block can obviously take either the little BH for the 2.77 trans or the larger BH for the 3.03 trans.
So it can take either the "dished" flywheel that goes with the 2.77 trans or the "flat" flywheel that goes with the 3.03 trans.
The question is -- is the same ~crankshaft~ used for both flywheels?
OR -- do both flywheels have the identical bolt-circle pattern?
OR - will the crankshaft from an earlier-year block -- say from a C5DE 200 CID block with ONLY the small BH pattern -- work in the C8DE block with the "flat" flywheel?