Maybe I’m just looking at nothing, but the area where the washer goes is not parallel. Is it normal? It’s not real far off, but enough that I noticed it.
I think some may match, but most do not.
You can get the manifolds milled to have the same thickness
or
fabricate stepped washers
or
if it's not to bad, live with sloped washers as long as you can get even pressure on both sides.
I think some may match, but most do not.
You can get the manifolds milled to have the same thickness
or
fabricate stepped washers
or
if it's not to bad, live with sloped washers as long as you can get even pressure on both sides.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.