Hi Mike do you have the cam spacer ring (wedding ring), the correct dowel pin, and the cam thrust plate with its bolts? Good luck
Econoline":31lnsp89 said:Can you give us a picture of the timing gears in that set?
bubba22349":31lnsp89 said:Hi Mike do you have the cam spacer ring (wedding ring), the correct dowel pin, and the cam thrust plate with its bolts? Good luck
bubba22349":1rtpbyuf said:Did you check how far the threads go into the cam to verafy the cam bolt length?
chad":lipjk0h6 said:if U would plez - a couple, 3 pic of the 3-intake-change you'll cast for the log (the 6 sides would B perfect, but anything...
chad":2o8w34je said:U cast near 1/2 decade ago that way (I think it wuz U)...
chad":2o8w34je said:I meant after U burry that in sand & it burns away.
bubba22349":2o8w34je said:Autolite 45's (Copper) are going to be very close on heat range, they are a very good lower cost plug, if you want to spend a bit more and want them to last even longer than you could go with some Platinum's.
chad":2aupqxaf said:still like to see/read as U go.
chad":12er0mew said:I did not know POR15 hada heat proof for motors, looks amazing in flat on my transfer case...
Like to put the heat proof on my alu muffler to make it last. Know how hi the heat it will take
(its plastic, right)?
chad":12er0mew said:"...satin nickel is what I painted the timing cover and thermostat housing with..." I coated my alu w/clear (K2, that stuff U gotta punch the button on the bottom of the rattle can). Hope it lasts.
pmuller9":26h5zpi9 said:Where did the intake lobe center end up?