The time has almost come to swap the OZ250 head with the CI aluminum head.
I finally cc'd the aluminum head @ 54cc
I don't remember what pistons are installed. Most likely sealed power dish.
Engine has been bored over .030
I am not sure which head gasket to use felpro or Corteco. I do have a c9oz-6079-a gasket set.
I don't think the block has been decked. It's been awhile.
Any wisdom or guidance is appreciated.
I finally cc'd the aluminum head @ 54cc
I don't remember what pistons are installed. Most likely sealed power dish.
Engine has been bored over .030
I am not sure which head gasket to use felpro or Corteco. I do have a c9oz-6079-a gasket set.
I don't think the block has been decked. It's been awhile.
Any wisdom or guidance is appreciated.